What Is Needed To Take Out Carpeting

Cut the carpet into workable sections and pull it free or roll it up and have a friend help you carry it out.

What is needed to take out carpeting.

Use a sharp new blade in your utility knife and be careful not to slice into baseboard or walls. It doesn t need to look good but make sure the measurements are accurate. In most cases the carpet padding will also need to be replaced or removed. Use pliers to tightly grab the carpet.

Carpet padding is usually just stapled down. It also helps to sketch out a diagram of your home s layout. The general guideline is that you will require 4 or the width of the stair x 30 of carpet for every pie stair this allows for some maneuvering of the carpet by the installer to find the best fit. Once the carpet is removed locate the nails which attach the tack strips to the floor.

Sure you start by figuring out the square footage but then you need to consider how many rolls of carpeting it will take to cover that amount of space with the smallest number or least. Pry bar hammer. Keep pulling back the carpet and slicing it into strips. It s usually easier to cut carpet from the back so when cutting it into small sections fold a section over revealing the back then slice through the woven backing with a utility or carpet knife.

Put on a pair of sturdy work gloves and start tearing up carpet in a corner of the room. When you re ready to buy the dealer will send a professional to take the final measurements. This will prevent any damage to the hardwood. Check out our handy carpet calculator if you need help measuring.

We like this knife by stanley which includes a quick change blade. Most retailers now sell by the square foot. Carpet is much easier to cut from the back than from the front. Then once the carpet is up lift the carpet pad off the floor a cut it with the utility knife.

If there s no need to save the carpet it is easier to cut the carpet into smaller sections with a utility knife and move the sections out one at a time. Pull toward you to detach it from the sharp tack strip that holds it to the floor along the wall. A utility knife hammer pry bar and floor scraper are your only tools of choice here. Pull it up cut it into smaller strips if necessary for handling and roll it as you did the carpet.

The work can be dusty so wear a dust mask and safety glasses.